Construction Cleaner CTH

Pre-moisten the surfaces to be treated and apply Construction Cleaner CTH using a handle brush or green pad/pad holder, covering the surface. Do not spray or generate an aerosol due to the high alkalinity. Depending on the staining, leave to take effect for between 10 mins to several hours, applying once again if necessary and using the brush or sponge for re-working. Rinse thoroughly using high pressure equipment. If large quantities (washing bay cleaner) are introduced into the industrial water system, the pH value range of the industrial water should be tested up to max. 9 and corrected if necessary. Spray arch cleaning: Special equipment and cleaning procedures are required for spray arch cleaning: the cleaning should preferably begin on the previous evening and the arch should be rinsed the next morning. All nozzles on the arch, up until the two lower nozzles, are replaced with blind plugs. Replace the lower nozzles with olive connectors and assemble with the hose ends. Now use a pressure pump bottle to squeeze Construction Cleaner CTH into the arch from below, via the hose ends, until product leaks from the other side. Close both hose ends with plugs, screws, or similar. The next morning, allow the dirty water to drain and thoroughly rinse the spray arch with water or the high pressure machinery. Then immediately rinse the equipment. Recommended equipment: Quasar pressure pump bottle, blind plugs, olive plugs, PE hose